seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Rear lock carrier trim, ST models: assembly overview Assembly overview > < Rear lock support cover Assembly overview
Rear lock carrier cover: Removing and installing.
Rear lock carrier cover: Removing and installing.
Special tools and workshop equipment required
   
t  Release lever -T20043-
Removal:
  W00-2324
–  Open the tailgate.
–  Fold carpeting in luggage compartment -5- to side.
–  Press rubber lip on tailgate to side and position lever -T20043- between rubber and cover for lock support at first clip.
–  Detach first clip in direction of -arrow- with lever -T20043-
–  Repeat same procedure for remaining clips -1- and remove cover for rear lock support upward.

Installation
   
Installation is carried out in the reverse order. When installing, note the following:
  Note
t  Before installing the trim check the condition of the clips-1- and replace if necessary.
t  Ensure that the lugs-3- on the cover for the rear lock support are inserted at the bolts-4-.

   

Rear lock carrier trim, ST models: assembly overview Assembly overview > < Rear lock support cover Assembly overview