seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Rear lock support cover Assembly overview > < Side trim in the luggage compartment, ST models: assembly overview Assembly overview

Leon Mk2

Side trim in the luggage compartment, ST models: assembly overview Removing and installing.
   
Side trim in the luggage compartment, ST models: assembly overview Removing and installing.
Special tools and workshop equipment required
t  Torque wrench kit -SAT 8010-
t  Release lever -T20043-
t  Release lever -U 30800-

Removal:
–  Open rear lid.
–  Remove the tray compartment.
   
–  Lift bench seat-1- at front and pull forward -arrow-.
–  Fold down the rear seat backrest. → Chapter.
–  Remove the idle pulley from the compartment → Chapter.
–  Remove the upper trim on C-pillar → Chapter.
–  Removing the lock carrier lining → Chapter.
–  Remove floor covering in luggage compartment.
  E72-10044
–  Detach clips -2- with the lever -T20043-.
–  Unscrew the bolt from retainer hooks -5-.
–  Remove side trim in boot -4-.

Installation
Installation is carried out in the reverse order. When installing, note the following:
  Note
t  Before fitting the lining check the condition of the caps and replace if necessary.
t  Check the tightening torques → Chapter
t  Adjust the rubber buffer -3- so that the backrest does not have any play in relation to the body.
   

Rear lock support cover Assembly overview > < Side trim in the luggage compartment, ST models: assembly overview Assembly overview