Leon Mk2
Note
| 1 - | Seal |
| q | Ensure seal is seated correctly after installing trim |
| 2 - | Cross-head screw |
| 3 - | Locking lug |
| 4 - | Cover |
| q | Old version |
| 5 - | Hexagon bolt |
| q | 40 Nm |
| 6 - | Seat belt with belt anchor |
| q | Old version |
| 7 - | Hexagon bolt |
| q | 40 Nm |
| 8 - | Cover |
| q | New version |
| 9 - | Seat belt with belt anchor |
| q | New version |
| 10 - | Clip |
| q | Destroyed during removal |
| 11 - | Trim panel |
| q | Removing: |
| – | Disengage locking lugs → Item and unclip cap → Item and remove upwards or unclip cap → Item and fold upwards |
| – | Unscrew belt guide fitting → Item or → Item |
| – | Remove cross-head screw → Item |
| – | Pull off B-pillar trim, starting at bottom, and unclip upper part. |
| q | Installing: |
| – | Lever clip → Item out of mounting hole of B-pillar, replace with new one and insert in trim mounting. |
| – | Further installation is performed in the reverse order of removal. |
| – | Check function of belt height adjustment |
|
| 1 - | Seal |
| q | Ensure seal is seated correctly after installing trim |
| 2 - | Cross-head screw |
| 3 - | Hexagon bolt |
| q | 40 Nm |
| 4 - | Cover |
| 5 - | Seat belt with belt anchor |
| 6 - | Trim panel |
| q | Removing: |
| – | Unclip cap → Item and fold upwards |
| – | Unscrew belt guide → Item |
| – | Remove cross-head screw → Item |
| – | Starting at bottom, pull trim off B-pillar and pull off at upper area downwards off carrier plate → Item. |
| q | Installing: |
| – | Installation is carried out in the reverse order. |
| – | Check function of belt height adjustment |
| 7 - | Ultrasound sensor |
| q | For interior monitoring |
| 8 - | Carrier plate |
| q | For ultrasound sensor |
| q | For installation and removal on pillar, turn by 90 degrees |
