Leon Mk2
Operating lever: removing and fitting |
Removing |
– | Pull the operation lever -1-, moving it some 2 cm |
– | Insert a small screwdriver between operation lever -1- and clip -2- |
– | Release the operation lever once again and remove the clip from the lever (the clip will fall behind the lining) |
– | Release the lining -3-, separating it from the central allotment, at a straight angle, and from the heel moulding, by the lower part |
Installation |
– | Fit the lining |
– | Fully insert the clip -2- onto the operating lever |
– | Next fit the operation lever in the corresponding support block |
– | Before closing front bonnet check the correct operation of the Bowden cable |