Leon Mk2
General assembly overview |
1 - | Bumper lining |
q | Material: PP/EPDM |
– | Removal of grill-bearing frame → Chapter. |
– | Removal of anagram grill. → Item |
– | Removing the bumper moulding → Chapter |
– | Removal of bumper linings → Chapter. |
2 - | Bumper moulding |
q | Clipped to the lining |
q | Removal causes imperfections |
3 - | Anagram grill |
– | Removing the release lever. → Chapter |
4 - | Bolt |
q | 3 units |
q | Tightening torque: 3 Nm |
5 - | Bolt |
q | Tightening torque: 6.5 Nm |
q | 4 units |
6 - | Drive hook cover |
q | Use the lever -U-30800- |
7 - | Bolt |
q | Tightening torque: 1.5 Nm |
8 - | Bolt |
q | 4 units |
q | Tightening torque: 20 Nm |
9 - | Side grill |
10 - | Bolt |
q | 4 units |
q | Tightening torque: 1.5 Nm |
11 - | Fixed guide for bumper lining |
12 - | Rivet |
q | 4 units |
13 - | Stopper |
14 - | Wheel housing moulding |
q | PP/EPDM Material |
15 - | Bolt |
q | 4 units |
q | Tightening torque: 1.5 Nm |
16 - | Bumper beam |
17 - | Bolt |
q | 4 units |
q | Tightening torque: 50 Nm |
18 - | Wind deflector brakes |
19 - | Bolt |
q | 4 units |
q | Tightening torque: 2 Nm |