–
| Cut the remaining material on the glass flange using the electric knife -SAT 1561- (use the rasp blade) but do not completely remove. |
Note The remaining material serves as an adhesive base for the new sealant paste. The sticking zones must be kept clean of dirt and grease. |
WARNING The activator must not come into contact with the paintwork; if this happens the paintwork could be damaged. |
|
t
| Exception: if gluing is not finished immediately after lowering the residual adhesive cords then the existing residual material must be activated, using the activator |
t
| If the bodywork flange has been reworked or partially replaced, after painting, the new zone must be cleaned and primed accordingly. |
|
|
|