Leon Mk2
| Front safety belts with tensioner system: removal and assembly |
| Model with tensioner unit on door strut. |
WARNING
|
| 1 - | Belt vertical control |
| q | Removal of belt height control → Chapter |
| 2 - | Cover |
| q | Fitted |
| 3 - | Support fittings |
| 4 - | Belt support fittings |
| q | Attached with 2 Philips screws |
| q | 1.5 Nm |
| 5 - | Belt automatic device |
| q | Removing → Anchor |
| q | The fastening tabs determine the position of the belt automatic device |
| q | The removal of used parts which have been triggered is carried out by the Distribution Centre or the Importer |
| 6 - | Safety nut |
| q | 20 Nm |
| q | Forms part of the tensioner unit |
| 7 - | Tensioner unit |
| q | Removing → Anchor |
| q | Forms part of the safety belt |
| q | On loosening the safety nut → Item, the belt tensor is locked, and on tightening it is reactivated |
| 8 - | Front support fittings |
| q | Removing → Chapter |
| 9 - | Front seat belt buckle |
| q | Removing → Chapter |
| Removing |
| – | Remove the heel moulding → Chapter |
| – | Remove the side lining or the lower lining from strut B → Chapter or → Chapter |
| – | Loosen the safety nut -6-; in this way, it is unbolted and the tensioner unit is unlocked -7- |
| – | Remove the belt support fastening -4-, the support fitting -3- and the front loop -8- |
| – | Undo the belt automatic device -5- |
| – | Remove the tensioner unit -7- from the supports |
WARNING
|
