Leon Mk2
| Front seat: removing and installing |
WARNING
|
| Instructions |
| t | When removing and fitting, there are certain differences in the working of the equipment which should be taken into account |
| t | Before disconnecting the battery, check the radio antitheft code |
| t | After reconnecting the battery check the vehicle equipment (radio, clock, electric windows), as shown in the Repair Manual and/or the Owners' Manual. |
| Removing |
| – | Move the seat forward. |
| – | Undo the hood -1- from the batten located on the side of the tunnel -3-, remove the bolt -2-, undo the batten from the seat rail -arrow A- and remove-arrow B- |
| – | Undo the hood -1- from the batten located on the side of the heel rest -4-, remove the bolt -2-, undo the batten from the seat rail -arrow C- and remove-arrow D- |
| – | Move seat backwards. |
| – | Remove the bolts -5- (23 Nm). |
| – | Take the seat back along the guide rails |
Note| Before separating the activation cable and the earth cable, any build up of electrostatic must be eliminated (touching the door slip switch or the bodywork) |
| – | Uncouple the side airbag connector -1- from the coupling station -2-. |
| – | Remove the connector for the seat heater from the coupling station, where there is one |
| – | Attach the connector -4- (airbag adapter -VAS 5094-) in the socket box -5- |
| Installation |
| Installation is carried out in reverse order. The following should be taken into account: |
Note| If, after assembly, the Airbag warning lamp -K75- lights up, the fault memory must be erased using the central diagnosis -VAS 5051- or the central diagnosis -VAS 5052-. After erasing the memory, consult the fault memory again → Vehicle diagnosis, testing and information system VAS 5051. |
