Leon Mk2
| Assembly overview: Flange shafts, seals and brackets on the bevelled gear |
| 1 - | Conical hexagon bolt |
| q | 480 Nm |
| q | Replace, → Spare Spare parts catalogue. |
| q | For output flange |
| 2 - | Output flange for the bevelled gear |
| 3 - | Seal ring cover for the output flange |
| q | Renew only if damaged |
| 4 - | Seal |
| q | For the output flange of the bevelled gear |
| q | → Chapter „ Seal for the pair of bevelled gears flange: replace“ |
| 5 - | Seal |
| q | Between gearbox and bevel box |
| q | → Chapter „Oil seal between the gearbox and pair of bevelled gears, in the pair of bevelled gears: replace“ |
| 6 - | Bevel box |
| q | removing and fitting → Chapter |
| 7 - | Oil drain plug |
| q | 60 Nm |
| q | For the bevelled gear |
| 8 - | Seal |
| 9 - | Filler and inspection plug |
| q | 15 Nm |
| q | Replace, → Spare Spare parts catalogue. |
| q | For the bevelled gear |
| 10 - | Bolt. |
| q | 40 Nm + 45° |
| q | replace |
| q | Four pieces, fixing the bevelled gear to the gearbox |
| 11 - | Purge tube |
| 12 - | Air hood |
| 13 - | Countersunk bolt |
| q | 30 Nm |
| q | Always replace. |
| 14 - | Right flange shaft |
| q | → Chapter „Removing and installing flange shaft (right-side)“ |
| 15 - | Oil seal |
| q | Always renew after removing flange shaft (right-side) |
| 16 - | Needle bearing |
| q | The needle bearing (polygon bearing) does not turn easily when the flange shaft is removed. This does not indicate that the bearing is defective. A test for noisy bearings can only be performed with the bearings installed |
| q | Take care for signs of damage to the bearings, e.g. such as cracking in outer race, replace if necessary |
| q | → Chapter „Renewing needle bearings (polygon bearings) for flange shaft (right-side)“ |
| 17 - | Support |
| q | The needle bearing (polygon bearing) does not turn easily when the flange shaft is removed. This does not indicate that the bearing is defective. A test for noisy bearings can only be performed with the bearings installed |
| q | Take care for signs of damage to the bearings, e.g. such as cracking in outer race, replace if necessary |
| q | → Chapter „Renewing needle bearings (polygon bearings) for flange shaft (right-side)“ |
| 18 - | Circlip |
| q | Always renew after removal |
|
|
|
