seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil and oil filter > < Gearbox mounting and gearbox support foot: Removing and installing

Leon Mk2

Pendulum support: dismounting and assembly
Pendulum support: dismounting and assembly
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Torque wrench kit -SAT 8010-, see equivalent → Anchor
  L00-10226
t  Socket -U-30025E -, see equivalent → Anchor
Removal:
  W00-2961
–  Fit the engine and gearbox support -U 30025E- on wing panel flanges and protect them against possible scratches.
–  Partly take up weight of engine with spindle, but do not lift.
–  Raise the vehicle.
  E13-10016
–  Remove the centre noise insulation -fastening parts 1 and 2-.
  A10-10761
–  Remove bolts -1, 2, 3- and detach pendulum support.
Installation
l  Tightening torques → Chapter
Installation is carried out in the reverse sequence; note the following:
–  First secure pendulum support to gearbox (bolts -2- and -3-), then on subframe -1-.
–  Install soundproofing → Rep. gr.66.
  A10-1578

Oil and oil filter > < Gearbox mounting and gearbox support foot: Removing and installing