Leon Mk2
| Gear selection mechanism, vehicles up to 02.2009: Assembly overview |
Note| Lubricate all bearings and moving surfaces with polycarbamide grease -G 052 142 A2-. |
| 1 - | Counter support |
| q | To fix the selector lever cable to the gearbox |
| 2 - | Bolt. |
| q | 23 Nm |
| q | To fix the counter support to the gearbox |
| q | 2 off |
| 3 - | Selector lever cable |
| q | Do not bend or kink |
| q | If the protective sleeve is damaged, the selector lever cable must be renewed |
| q | verification and adjustment → Chapter |
| q | removing and fitting → Chapter |
| q | Do not grease the shaft ring or ball socket |
| 4 - | Nut |
| q | 13 Nm |
| q | for fixing the bracket → Item to the gearbox |
| q | 2 off |
| 5 - | Spring retainer |
| q | For the selector lever cable |
| 6 - | Nut |
| q | 10 Nm |
| q | 4x |
| q | For fixing the gear selector mechanism to the bodywork |
| 7 - | Rubber stop for the selector lever |
| q | Is fixed to the gear selector mechanism |
| 8 - | Shift unit |
| q | Operating manual release mechanism, vehicles with selector lever boot → Chapter |
| q | There are different versions depending on the series-production. The handle of the front interlock button cannot be mounted in an actuating unit with interlock button on one side (and vice versa) |
| q | removing and fitting → Chapter |
| q | With integrated printed circuit for selector mechanism (selector lever - E313-), do not touch |
| q | With integrated tiptronic switch -F189- and selector lever lock solenoid -N110-, which can both be checked in „Guided fault finding“, using the → Vehicle diagnostic tester |
| q | The tiptronic switch -F189- can only be renewed together with the selector mechanism unit → Chapter. |
| q | The tiptronic switch -N110- can only be renewed together with the selector mechanism unit → Chapter. |
| 9 - | Insertion spring |
| 10 - | Bolt. |
| q | 3.5 Nm |
| 11 - | Bearing pin |
| q | For securing selector lever cable to selector mechanism |
| 12 - | Bolt. |
| q | 3.5 Nm |
| q | 4x |
| q | For fixing the insertion plate to the gear selector mechanism |
| 13 - | Insertion plate |
| 14 - | Panel |
| q | For the gear selection mechanism. |
| q | With gasket attached |
| 15 - | Nut |
| q | 9 Nm |
| q | Self-locking |
| q | replace |
| q | For securing cover to selector mechanism |
| q | 4x |
| 16 - | Locking plate |
| q | replace |
| q | For fixing the selector lever cable to the support unit |
