SEAT Workshop Service and Repair Manuals

• H.T. cable
• ◆ 4...8 kω
• ◆ With suppression connector and spark plug connector
• ◆ Check for continuity
• Ignition transformer (N152)
• ◆ Marked for H.T. cables:
  A = Cylinder 1
  B = Cylinder 2
  C = Cylinder 3
  D = Cylinder 4
• ◆ Checking
• 10 Nm
• Connector
• ◆ 4 pin
• Knock sensor 1 (G61)*
• ◆ Contacts gold plated
• ◆ Checking => Page 28-15

• 2-pin connector
• ◆ For knock sensor 1 (G61)
• ◆ Contacts gold plated
• ◆ Do not interchange
• Knock sensor 2 (G66)*
• ◆ Contacts gold plated
• ◆ Checking => Page 28-15
• ◆ Next to ignition transformer
• 2-pin connector
• ◆ For knock sensor 2 (G66)
• ◆ Contacts gold plated
• ◆ Do not interchange
• 20 Nm
• ◆ Tightening torque influences the function of the knock sensor
• Spark plug, 25 Nm
• ◆ Type and electrode gap
  => Page 28-6, test data, spark plugs
• ◆ To remove and install pull off the connectors for the outer injectors
• ◆ Remove and install with 3122B

• Connector
• ◆ Contacts gold plated
• ◆ 3 pin
• 10 Nm
• 100 Nm
• ◆ Use counter-hold tool 3415 to loosen and tighten
• Camshaft sprocket
• ◆ With rotor for Hall sender
• ◆ Removing and installing:

=> Repair group 15; Servicing valve gear

• Hall sender (G40)*
• ◆ Checking => Page 28-7
• Bracket
• ◆ For Hall sender