SEAT Workshop Service and Repair Manuals

To prevent injuries to persons and/or damage to the injection and ignition system, the following must be observed:

• ◆ Do not touch or pull off ignition wiring when engine is running or turning at starter speed.
• ◆ The ignition must be switched off when disconnecting or connecting injection and ignition system wiring as well as test instrument cables.
• ◆ If the engine is to be turned at starter speed, without starting:

• ‒ → Pull 4 pin connector -1- off ignition transformer (N152) -2-.

• ‒ → Remove fuse No. 14 (fuel pump relay) from fuse holder.

Observe following if test and measuring instruments are required during a test drive:

• ◆ Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location.

• If test and measuring instruments are operated from front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.