SEAT Workshop Service and Repair Manuals

To prevent injuries to persons and/or damage to the fuel injection and ignition system, the following must be noted:

• ◆ Do not touch or disconnect ignition wiring when the engine is running or being turned at starter speed.
• ◆ The ignition must be switched off before connecting or disconnecting injection or ignition system wiring or tester cables.
• ◆ If the engine is to be turned at starter speed, without starting:

• ‒ → Pull all 4 pin connectors -2- off ignition coils -1-.

• ‒ → Pull connectors off injectors.

Observe following if test and measuring instruments are required during a test drive:

• ◆ Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location.

• If test and measuring instruments are operated from front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.