SEAT Workshop Service and Repair Manuals

• Activated charcoal filter
• ◆ Location: in front right wheel housing
• ◆ Activated charcoal filter system

=> Repair group 20; Activated charcoal filter system

• Air cleaner
• Activated charcoal filter solenoid valve 1 (N80)
• ◆ Checking, Final control diagnosis
• ◆ Activated charcoal filter system

=> Repair group 20; Activated charcoal filter system

• Air mass meter (G70)
• Charge pressure limitation solenoid valve (N75)
• ◆ Checking=> Page 01-88, Final control diagnosis
• ◆ Charge pressure system:

=> Repair group 21; Checking charge pressure system; Checking charge pressure control solenoid valve

• Ignition coil with output stage (N70, N127, N291, N292)
• ◆ , item 3
• Lambda probe connectors
• ◆ On underside of vehicle
• ◆ 6-pin for Lambda probe 1 before catalyst (G39) and Lambda probe heater (Z19)
• ◆ 4-pin for Lambda probe 2 after catalyst (G130) and Lambda probe heater (Z19)
• Fuel pressure regulator
• Combi-valve
• ◆ Secondary air system:

=> Repair group 26; Secondary air system; Removing and installing parts of secondary air system

• Coolant temperature sender (G62)

• EGR valve (N18) with exhaust gas recirculation potentiometer (G212)
• ◆ Checking N18=> Page 01-88, Final control diagnosis
• ◆ Checking G212:

=> Repair group 26; Exhaust gas recirculation system

• Clutch pedal switch (F36), brake light switch (F) and brake pedal switch
• Engine control unit
• (Motronic control unit -J220)
• 14-pin connector
• ◆ Engine connector
• Additional fuse holder
• Throttle valve control part (J338)
• Charge pressure sender (G31)*

• Intake air temperature sender (G42)
• 3 pin connector
• ◆ Grey for engine speed sender (G28)
• Knock sensor 1 (G61) and knock sensor 2 (G66)
• ◆ , item 7
• ◆ => Page 28-3, item 8
• Injector (N30...N33)
• Secondary air pump motor (V101)
• ◆ Secondary air system:

=> Repair group 26; Secondary air system; Removing and installing parts of secondary air system

• Hall sender (G40)
• ◆ => Page 28-3, item 11