| Removing and refitting the compressor pulley (compressor make “Denso”, version “1”) |
Note! | t
| If the overload protection has been activated, before replacing the pulley check the compressor moves freely. If the compressor movement is difficult, replace entirely. |
| t
| The operation of the overload protection of the version “1” is described as an example in the self-learning program. |
| t
| To remove the pulley, it may be necessary to loosen the engine compressor, depending on the engine version. |
| t
| The compressor can be detached from the support and re-attached without opening up refrigerant pipes. |
| t
| Before removing the Poly-V belt, mark the direction of rotation with chalk or felt tip. If used in reverse direction, this may damage a belt which has been used beforehand. |
| t
| Depending on the engine fitted and the country, different compressors are fitted → Parts catalogue. |
|
|
|
