SEAT Workshop Service and Repair Manuals

Removing and installing control and display unit Special tools and workshop equipment required

t  Removal wedge -3409- Removal:

–  Remove sliding control for fresh and recirculated air -1- in -direction of arrow-.

–  Unclip trim -1- using removing wedge -3409- at relevant locations -arrows- and remove trim -1-.

–  Remove bolts -1- (1.5 Nm). –  Remove radio → Communication; Rep. gr.91 or centre trim → General body repairs, interior; Rep. gr.70.

–  Unhook control and display unit -1- in -direction of arrow- from mountings -arrows A- and pull it out frontwards. –  Disconnect connectors from control and display unit -1-.

–  Detach flexible shafts -1- for defroster and air distribution flap and temperature flap as well as fresh air/recirculated air flap cable from control and display unit -2-. –  Remove control and display unit.   Note The flexible shaft connexion -3- is referred to as „terminal“. Installation –  Installation is carried out in the reverse order; noting the following in the process: t  Always install slide control for fresh air/recirculated air with plug-in socket pointing upwards.   Note When the flexible shafts are installed, the actuators and rotary knobs on the heated air and fresh air controls must be positioned correctly relative to each other, or the system will malfunction.