| –
| Unfasten drive plate -C- by turning it with a commercially available strap wrench (with fabric strap) in direction of arrow -D-. Provide support for compressor shaft -A- by applying counter hold -B- (e.g. socket wrench -T10001/10- from wrench set or special tool 3079) to compressor shaft -A-. |
Note | There are different types of compressor drive shaft. The drive shafts fitted at the start of production cannot be supported using an Allen key (use socket wrench -T10001/10- for example). Use was later made of compressors with a hexagon end on the drive shaft. |
|
|
|
