| The position of the flaps can be altered by pressing the corresponding control buttons: |
| t
| Temperature flap control motor -V68- |
| –
| Press control button -3- or -6- until the “Hi” or “Lo” display on the display field of Climatronic control unit -J255- appears. |
| This will cause the temperature flap control motor -V68- to move once through its entire range. |
| t
| Front air distribution control motor -V145- |
| –
| Press control button -1- or -7-. |
| The control motor is now moved once through its entire range. |
| t
| Centre vent control motor -V102- |
| –
| Press control button -2-. |
| The control motor is now moved once through its entire range. |
| t
| Rear temperature flap control motor -V137- |
| Only on vehicles with 2nd evaporator |
| –
| Press control button -4- or -5- until “Hi” or “Lo” appears in display field of Climatronic control unit -J255-. |
| This will cause the rear temperature flap control motor -V137- to move once through its entire range. |
| t
| Rear air distribution control motor -V136- |
| Only on vehicles with 2nd evaporator |
| The actuation of therear air distribution control motor -V136- is map controlled. The function can be checked as follows using the control buttons: |
| –
| Press control button -4- until “Hi” appears in display field of Climatronic control unit -J255-. |
| In the “Hi” setting, air is sent only to the footwell vent. |
| –
| Press control button -5- until “Lo” appears in display field of Climatronic control unit -J255-. |
| In the “Lo” setting, air is sent only to the footwell vent and to the roof vents. |
|
|
|
