Leon Mk2
→ Rep. Gr.13 |
1 - | Bracket for alternator, compressor and injection pump |
Removing |
– | Alternator: removing → Electrical system; Rep. Gr.27 |
– | Remove the compressor from the support and fix it to the body with a suitable tool (e.g. soldering wire) → Fig.. |
– | Loosen the bolts that fix the bracket to the cylinder block. |
Fitting |
t | Before fitting, it is necessary to: |
– | Replace fixing bolts. |
– | Note the order of tightening of the securing bolts. |
t | Tightening torques: First, tighten hexagon bolts -A,B,C,D,E- and then hexagon bolt → Item-F-. |
2 - | Hexagon bolt M10x55 |
q | 50 Nm |
q | 6 units |
3 - | Compressor |
q | Removing: |
– | Remove the hexagon bolts, → Item. |
– | Remove the compressor from the support and fix it to the body with a suitable tool (e.g. soldering wire) → Fig.. |
4 - | Hexagonal combi bolt |
q | M8X100 |
q | 25 Nm |
q | 3 units |
5 - | Dowel sleeves |
q | 2 units |
q | Make sure the cylinder head supports are correctly seated. |
6 - | Tensioning device for Poly-V belt |
7 - | Tensioning element for the tensioning roller |
|
Note
|