seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
To remove and fit the pulley version ?2? > < Replacing the pulley (compressor of the ?Denso? brand, version ?2?)

Leon Mk2

Removing and refitting the compressor pulley (“Denso” brand compressor, version “2”)
Removing and refitting the compressor pulley (“Denso” brand compressor, version “2”)
  Note
t  Note the comments for removal of the pulley version “1” because these are also valid for the removal of version “2” → Chapter.
t  Carry out the preparation work as described for the removal of the pulley version “1” → Chapter.
t  The pulley is made from plastic and is quite fragile, for this reason manipulate it with due care.
   
t  If the drive plate -C- protection against overload has been activated, the drive plate may be levered easily following the removal of the circlip -A- from the pulley -D-.
  E87-10004
t  To reduce the noise, the pulley drive plate -A- can incorporate a plastic disk -B- → Spare parts catalogue. This disk -B- reduces the rattling noise of the pulley, which may occur in Diesel engine vehicles in “Econ” mode (activation of the compressor cancelled) (the noise is barely perceptible when the air conditioning is full on).
  A87-10128

To remove and fit the pulley version ?2? > < Replacing the pulley (compressor of the ?Denso? brand, version ?2?)