Leon Mk2
Cover of the gearbox housing and 5th gear: removing and refitting |
1 - | Hexagonal bolt, M8×80, 25 Nm |
q | 3 units |
2 - | Washer |
3 - | Oil fill stopper, 25 Nm |
q | Screw in applying sealant or protective material -D 000 600 A2-. |
4 - | Hexagonal bolt, M8×45, 25 Nm |
5 - | Hook |
6 - | Lid for the gearbox housing |
7 - | Fixing pin |
q | 5 x 22 |
8 - | Fork for 5th gear |
q | Removal → Chapter |
9 - | Spring |
10 - | 5th gear movable |
11 - | 5th gear synchroniser |
12 - | Locking parts (3 units) |
13 - | Hexagonal nut, 100 Nm |
q | This must always be replaced after removal |
q | Follow the corresponding fitting sequence to loosen or tighten → Chapter |
14 - | 5th gear pinion |
15 - | Gearbox housing |
16 - | Bushing for needle bearing |
q | Fitting position: the oil gaps -arrow- face the 5th gear synchroniser. |
17 - | Needle bearing |
18 - | Sliding pinion 5th gea |
19 - | 5th gear synchroniser ring |
20 - | Support ring |
q | Prevents the locking parts from coming loose |
21 - | Leaf spring |
q | Fitting position: the exterior diameter (concave side) faces the 5th gear |
22 - | Hexagonal nut, 60 Nm |
q | This must always be replaced after removal |
q | Follow the corresponding fitting sequence to loosen or tighten → Chapter |