seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing over-centre spring|Installation > < Removing and installing over-centre spring

Leon Mk2

Removal:
Removal:
l  Clutch pedal support stand removed → Chapter
–  Move pedal to highest position. Take care that over-centre spring does not jump out of neutral.
  Note
When the securing bolt is removed from the clutch pedal, take the precaution of lightly holding the clutch pedal so that it does not jump out of neutral.
   
–  Disconnect clutch pedal -1- from the assembly support holder -3- . To do so the nut -2- must be unscrewed, the clutch pedal must be slightly pressed, the screw -5- must be loosened and at the same time the over centre spring -4- must be removed.
  Note
t  Clutch pedal must remain connected to master cylinder actuating rod -arrow-.
  A30-0125
t  Grease all of the contact points with the spherical pivot and all the contact surfaces with grease, according to → Electronic spare parts catalogue (ETKA).
  E30-10013

Removing and installing over-centre spring|Installation > < Removing and installing over-centre spring