Leon Mk2
Note
|
1 - | Base plate |
q | Straighten tabs for removal |
q | replace |
2 - | Seal |
q | Replace if worn |
3 - | Gear lever |
4 - | O ring |
q | Replace if worn |
5 - | Securing clip |
6 - | Selection control cable |
q | removing and fitting → Chapter |
q | Adjust convergence → Chapter |
7 - | Gear selector cable |
q | removing and fitting → Chapter |
q | Adjust convergence → Chapter |
8 - | Retainer washer |
9 - | Frame |
q | For compression spring → Item |
10 - | Bearing shell with damper element |
11 - | Panel |
12 - | Thrust piece |
13 - | Retainer washer |
q | removing and fitting → Fig. |
14 - | Compression spring |
15 - | Thrust piece |
16 - | Bolt, 6 Nm |
17 - | Retainer washer |
18 - | Mounting bush |
19 - | Gear lever guide |
20 - | Nut |
q | M6 |
q | 20 Nm |
21 - | Seal |
q | Between gear lever casing and vehicle underbody |
q | Self-adhesive |
22 - | Gear lever casing |
23 - | Mounting bush |
24 - | Bearing pin |
25 - | Guide sleeve |
q | Press into gear lever casing |
26 - | Compression spring |
q | Fitting → Fig. |
27 - | Bolt. |
q | 5 Nm |
28 - | Selector bracket |
|