Leon Mk2
| Switching unit: Assembly overview |
| 1 - | The gear selection mechanism |
| q | Consists of selector shaft and selector shaft cover |
| q | Components cannot be separated from each other |
| q | removing and fitting → Chapter |
| 2 - | Reversing light switch -F4- |
| q | Tighten to 20 Nm |
| q | Apply a thin coat of lubricating grease → Electronic spare parts catalogue (ETKA). |
| 3 - | Locking pin |
| q | For adjusting selector mechanism |
| 4 - | Idler rod |
| q | installation position |
| q | May be plastic or metallic |
| 5 - | Mounting bush |
| q | Not required if the idler rod is plastic |
| 6 - | Seal |
| q | Remove with extractor -T20143- |
| q | replace → Chapter |
| 7 - | Conical hexagon bolt |
| q | Tighten to 23 Nm |
| q | Self-locking |
| q | Always replace. |
| 8 - | Gearbox selector lever |
| q | Attach in such a way that the interrupted cog area aligns with the selection shaft |
| q | Can be renewed with the selector mechanism installed |
| q | Installation position → Fig. |
| 9 - | Cap |
| q | For gearbox breather |
| 10 - | Retainer washer |
| q | Always replace. |
| q | Not required if the idler rod is plastic |
| 11 - | Sealing plug |
| 12 - | Spring |
| q | Not fitted in all gearboxes |
| q | If installed, re-install |
|
|
|
|
