| Control measurement of clutch play between -K1- and -K2- |
| –
| The clutch play can only be measured after installing the ATF pump. |
| –
| Place the -T20020- tool on the gearbox casing. Fit a dial gauge and adjust it to “0” with 1 mm of pre-tension. |
| –
| Fit the -T20003- tool to the turbine shaft, paying special attention when doing so that no interference is caused on shaft movement that would give a false reading on the dial gauge measurement. |
| –
| Move the turbine shaft up and down using the -T20003- tool and read the play with the dial gauge. |
|
|
|
