Leon Mk2
| I - ATF pump to support pipe: removal and fitting |
| t | Planet gear: removal → Chapter |
| t | Planet gear: fitting → Chapter |
| 1 - | 8 Nm + 1/4 turn (90°) |
| q | Tighten in various stages |
| 2 - | ATF pump with piston -B2- |
| q | Allocate the spare part according to the gearbox codes |
| q | Dismantling and assembling → Chapter |
| 3 - | O-ring |
| q | Renew |
| q | Fit it to the ATF pump |
| 4 - | Gasket |
| q | Renew |
| 5 - | Spring guide crown |
| q | 6 units |
| q | Fit 3 spring guide crowns after fitting the first outer disk |
| q | Fit 3 spring guide crowns before fitting the last outer disk |
| 6 - | Spring |
| q | 3 units |
| 7 - | retainer ring |
| 8 - | Shim |
| 9 - | Outer disk -B2- |
| q | 3 mm thick |
| 10 - | Inner disk -B2- |
| q | Number of disks → Chapter |
| q | Before fitting the inner disks, leave them soaking in ATF for 15 min |
| 11 - | Outer disk -B2- |
| q | Always fit 2 mm thick outer disks |
| q | Number of disks → Chapter |
| 12 - | Outer disks -B2- |
| q | Place a 3 mm thick disk on the support disk |
| 13 - | Support pipe -B2- |
| q | For the -B2- disk package |
| q | Allocate the spare part according to the gearbox codes |
| q | Position so that the recess fits into the free wheel wedge |
| 14 - | Gearbox casing with fitted clutches |
