Leon Mk2
| II - Reverse gear clutch -K2- to long planet gear: removal and fitting |
| t | Planet gear: removal → Chapter |
| t | Planet gear: fitting → Chapter |
| 1 - | Reverse gear clutch -K2- |
| q | Dismantling and assembling → Chapter |
| 2 - | Shim |
| q | Determine the thickness: adjusting the clutch clearance between -K1- and -K2- → Chapter |
| q | Up to 3 shims can be fitted |
| 3 - | Clutch from 1st up to 3rd gear -K1- |
| q | Allocate the spare part according to the gearbox codes |
| q | Clutches -K1- and -K3- are snap-fitted one on top of the other |
| q | Dismantling and assembling → Chapter |
| 4 - | O-ring |
| q | Always renew |
| q | Remove -K1- from -K3- to change it → Chapter |
| 5 - | Clutch from 3rd up to 4th gear -K3- with turbine shaft |
| q | Allocate the spare part according to the gearbox codes |
| q | Clutches -K1- and -K3- are snap-fitted one on top of the other |
| q | Dismantling and assembling → Chapter |
| 6 - | Clutch from 1st up to 3rd gear -K1- with 3rd and 4th gear clutch -K3- |
| q | Clutches -K1- and -K3- are snap-fitted one on top of the other |
| q | Remove -K1- from -K3- → Chapter |
| q | Fit -K1- onto -K3- → Chapter |
| 7 - | Axial needle bearing with washer |
| q | The axial needle bearing faces towards the satellite carrier shaft |
| 8 - | Satellite carrier shaft |
| 9 - | Needle bearing |
| 10 - | Axial needle bearing |
| 11 - | Short planet gear shaft |
| 12 - | Axial needle bearing |
| 13 - | Washer for the axial needle bearing |
| q | With shoulder |
| 14 - | Long planet gear |
| 15 - | Axial needle bearing |
| 16 - | Washer for axial needle bearing |
| 17 - | Gearbox casing with free wheel and safety rings fitted |
