Leon Mk2
III - Free wheel and reverse gear brake -B1-: removal and fitting |
t | Planet gear: removal → Chapter |
t | Planet gear: fitting → Chapter |
1 - | Safety ring |
q | For the support pipe -B2- |
q | Fitting position: the open end must be facing the free wheel support wedge |
2 - | Safety ring |
q | For the free wheel |
q | Fitting position: the open end must be facing the free wheel support wedge |
3 - | Free wheel with -B1- piston |
q | Before removing the free wheel, remove the slide box and the union plugs → Chapter |
q | Dismantling and assembling → Chapter |
4 - | Plate spring |
q | The rounded side must face the free wheel |
5 - | Support disk -B1- |
q | Fit the flat side facing the disks |
q | Allocate the spare part according to the gearbox codes |
6 - | Inner disk -B1- |
q | Number of disks → Chapter |
q | Before fitting the inner disks, leave them soaking in ATF for 15 min |
7 - | Outer disk -B1- |
q | Number of disks → Chapter |
8 - | Shim |
q | Determine thickness → Chapter |
9 - | Gearbox casing with fitted satellite carrier |