Leon Mk2
Parking lock: removal and installation |
Special tools and workshop equipment required |
t | Torque spanners -SAT 8010- |
t | Plunger -U-40027- |
t | Extractor -U-40087- |
t | KIT -U-40200 A- |
Note!
The driven sprocket must be removed to remove and fit the parking lock → Chapter |
1 - | 4 Nm |
q | Replace the steel spring and the control bolt on the manual slide control → Fig. |
2 - | Manual slide control |
q | Adjust → Fig. |
q | Replace the steel spring and the control bolt on the manual slide control → Fig. |
3 - | Selector rod with connection piece |
q | Removing and installing → Fig. |
4 - | Support sleeve |
q | Removing and installing → Fig. |
5 - | Meshing lever |
q | Position it with the selector rod and meshing lever |
6 - | Meshing piece |
q | Position it with the selector rod and meshing lever |
7 - | Safety washer |
8 - | 10 Nm |
9 - | Control piece spring |
10 - | 10 Nm |
11 - | Safety ring |
q | Renew |
q | Fit it only on rods with recesses for safety rings |
12 - | Washer |
13 - | Shafts for safety levers |
q | Secure using the safety rings and the crown pinion shaft bearing cover |
14 - | Recuperation spring |
q | Fit → Fig. |
15 - | Securing lever |
q | Fit with the recuperation spring → Fig. |
16 - | Parking lock sprocket |
q | The rounded side must face the toothing on the crown pinion shaft |
17 - | 14 Nm |
18 - | Support tab |
q | Assembly → Fig. |
19 - | Guide plate |
q | Position before the support tab → Fig. |
20 - | Gearbox casing |
q | To disarm the parking lock, it is not necessary to remove the pinion wheel |
21 - | O-ring |
q | Renew |
22 - | Multi-function switch -F125- |
q | Removing and installing → Fig. |
q | Check on the vehicle by self-diagnosis → VAS 5051; Vehicle self-diagnosis |
23 - | Support |
q | For multi-function switch |
24 - | 10 Nm |
25 - | Starter motor bush bearing |
q | Remove → Fig. |
q | Fitting → Fig. |
26 - | O-ring |
q | Renew |
27 - | Road speed sender -G68- |
q | Removing and installing → Fig. |
q | Check on the vehicle by self-diagnosis → VAS 5051; Vehicle self-diagnosis |
28 - | 10 Nm |
29 - | O-ring |
q | Renew |
30 - | Gearbox rev. speed sender -G38- |
q | Removing and installing → Fig. |
q | Check on the vehicle by self-diagnosis → VAS 5051; Vehicle self-diagnosis |
31 - | 10 Nm |
32 - | Support |
q | For the speed sender cable |
q | Secure using the bolt → Item |
33 - | Securing clip |
q | For the speed sender cable |
34 - | Lever |
q | For connecting shaft |
35 - | 10 Nm |
36 - | Selector rod oil seal |
q | Fit with tool -U-40200/15- |
37 - | Breather cap |
38 - | Breather piece |
39 - | Breather pipe |
q | Remove with pliers |
|
|
|
|
|
|
|
|