seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Engine: fitting > < Detaching engine from gearbox
Attaching engine to repair stand
Attaching engine to repair stand
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
   
Special tools and workshop equipment required
t  counterhold -T20127-, see equivalent → Anchor
t  base -T20172/1-, see equivalent → Anchor
t  Tower -T20172/2-, see equivalent → Anchor
t  Engine bracket -T20172/3-, see equivalent → Anchor
t  Workshop crane

Requirements:
l  Gearbox is separated from engine
Operation process
  Note
To align the assembly centre fit the counterhold -T20127- to the anchorage points as shown in the figure.
   
–  Insert struts of the retaining device -T20127-. into the corresponding anchorage points.
  DANGER!
Ensure that the hooks are closed with the security rings.
–  Raise the engine from the counterhold -T20205- lifting it using the workshop crane and lower it.
  Note
If operations are planned for the crankshaft or sealing flanges, the flywheel and intermediate plate must be removed before fixing to the engine bracket -T20172/3-.
–  Place the engine support -T20172/3- carefully on the engine, and then fasten it on the base -T20172/1- together with the tower -T20172/2-.
  E10-0109

Engine: fitting > < Detaching engine from gearbox