SEAT Workshop Service and Repair Manuals

Removing and installing cylinder head cover Removing → Anchor Installing → Anchor Special tools and workshop equipment required t  Torque wrench -SAT 8010-

t  Sealant →  Parts catalogue

t  Extra long arm -T20203-

Removing –  Remove the sound proofing from the engine by pulling forcefully upwards -arrows- . –  Remove upper notched belt guard. –  Remove the crankshaft sump ventilation hose at the entry to the tube behind the supercharger air. –  Unscrew the bolts on the cylinder head cover with the extralong arm for the 1/4 head -T20203- and remove it. Installing Installation is carried out in the reverse order of removal while noting the following:   Note If there is damage, replace the gasket and the cylinder head bolts.

–  Apply a drop of sealant →  Electronic spare parts catalogue (Ø approx. 5 mm) -arrows- to both sealing surface ends of the front bearing cover / cylinder head.

–  Apply a drop of sealant →  Electronic spare parts catalogue (Ø approx. 5 mm) -arrows- to both sealing surface ends of the rear bearing cover / cylinder head.

–  Manually tighten the bolts for the cylinder head cover in the sequence -1 … 13- . –  Tighten the bolts to 10 Nm in the following order -1 ...13- .