Leon Mk2
|
1 - | Upper protection element for the notched belt |
2 - | Notched belt |
q | Mark direction of rotation before removing. |
q | Check for wear |
q | Do not bend |
q | removing and fitting → Chapter |
3 - | 10 Nm |
4 - | 25 Nm |
5 - | 100 Nm |
6 - | Camshaft wheels |
7 - | Hub |
q | With generator wheel |
q | Use counter-hold tool -T10051- to loosen and tighten. |
q | For removal use the extraction tool -T10052A- |
q | removing and fitting → Chapter |
8 - | Rear notched belt guard |
9 - | Sleeve |
q | If this is damaged, replace it |
10 - | Hall sender -G40- |
q | For the camshaft position |
q | To remove, unfasten sealing sleeve from rear of the timing belt guard → Item |
11 - | Cylinder head bolt |
q | Replace |
q | Observe sequence when loosening and tightening → Chapter. |
q | Prior to installation, insert washers in cylinder head |
12 - | 10 Nm |
q | For engine cover |
13 - | Cylinder head cover |
q | With oil filler mouth |
q | If the cylinder head cover is damaged then the oil filler mouth must also be replaced. |
q | removing and fitting → Chapter |
q | Before fitting, clean thoroughly the seal surface of the cylinder head using a clean cloth |
14 - | Hose |
q | Goes to the supercharger air tube → Item |
15 - | 10 Nm |
q | First tighten all bolts by hand |
q | Next, first tighten the two bolts above and then the remaining bolts crossways from the interior towards the exterior to the indicated torque |
16 - | Pressure limiting valve |
q | For engine block ventilation pre-heater |
17 - | Oil filler cap |
q | Replace |
18 - | Sealing plug |
q | Replace gasket if it shows signs of damage. |
19 - | Seal collaret |
q | If this is damaged, replace it |
20 - | Spring retainer |
q | With 2 fuel lines |
q | With the coolant tube |
21 - | Cylinder head cover gasket |
q | If this is damaged, replace it |
22 - | 20 Nm |
23 - | Spring retainer |
24 - | Injector pump |
q | removing and fitting → Chapter |
25 - | Central connection |
q | For the injector pump |
26 - | Hose |
q | of the brake servo |
27 - | Tandem pump: |
q | For fuel feed and low pressure |
q | removing and fitting → Chapter |
q | Checking → Chapter |
28 - | Intake hose |
q | From fuel filter. |
q | White or with white marking. |
q | Check for secure seating. |
q | Immobilise with spring clips |
29 - | Return hose |
q | To fuel filter |
q | Blue or with blue marking. |
q | Check for secure seating. |
q | Immobilise with spring clips |
30 - | Seal |
q | Replace |
31 - | Spring retainer |
32 - | Conical hexagon bolt |
33 - | Cylinder head |
q | removing and fitting → Chapter |
q | Renew coolant after replacing cylinder head gasket |
34 - | Cylinder head gasket |
q | Replace |
q | Note marking → Fig.. |
q | Renew coolant after replacing cylinder head gasket |
35 - | Glow plug, 15 Nm |
q | Checking → Chapter |
36 - | Tensioning roller |
q | To avoid significant damage to the engine apply correct tightening torques |
37 - | 20 Nm + 45° (1/8 turn) |
Note
|