seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil pressure and oil pressure switch: checking > < Oil pump: removing and installing

Leon Mk2

Oil supply pipe: removing and fitting
Oil supply pipe: removing and fitting
t  Removing → Anchor
t  Installing → Anchor
Removing
–  Remove the air filter housing → Chapter.
   
–  Disconnect electrical connection -1- from the oil pressure switch -F1-.
–  Undo fastening bolt of oil filter bracket -3- and fastening bolt of clamp -4-.
  A21-0301
–  Fit the centre noise insulation -fasteners 1 ... 3-.
  A10-1565
–  Undo the fastening bolts of the turbocharger and of the bracket -arrows-.
–  Remove the oil feed tube,
Installing
Installation is carried out in the reverse order of removal while noting the following:
  Note
The procedure sequence should be followed in order to guarantee a stress-free assembly of the fuel supply pipe.
–  Fix the coupling bolts of the oil supply pipe onto the oil filter bracket connections and the turbocharger by hand.
  A21-0306
–  First tighten the coupling bolt -3- of the oil filter bracket to 22 Nm.
  A21-0301
–  Tighten turbocharger coupling nut -arrow- to 22 Nm.
–  Fit the clamps on the brackets and tighten the fastening bolts to 10 Nm.
–  Install air cleaner housing → Chapter.
–  Check oil level → Fig.
  A21-0306

Oil pressure and oil pressure switch: checking > < Oil pump: removing and installing