seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
C - Screw the fitting deviceT10134 onto the crankshaft flange > < A - Fit the seal along with the sender wheel on the fitting deviceT10134

Leon Mk2

B - Attaching assembling toolT10134 with sealing flange on crankshaft flange
B - Attaching assembling tool -T10134- with sealing flange on crankshaft flange
l  The crankshaft flange must be free of oil and grease.
l  The engine should be in TDC cylinder 1.
   
–  Screw in the hexagonal nut -B- to the end of the threaded spindle.
–  Press the threaded spindle of the fitting device -T10134- in the direction of the arrow until the hexagonal nut -B- is in contact with the installation socket -A-.
–  Align flat side of assembly housing to crankcase's sealing surface on the oil sump side.
  N13-10045
–  Secure the fitting device -T10134- using the Allen bolts -A- to the crankshaft flange.
  Note
Screw the Allen screws -A- by approx. 5 threads into the crankshaft flange.
  N13-10044
–  Screw in the 2 bolts M7×35 mm -A- on the engine block to guide the sealing flange.
  N13-10031

C - Screw the fitting deviceT10134 onto the crankshaft flange > < A - Fit the seal along with the sender wheel on the fitting deviceT10134