seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Balance shaft and shaft bracket: removing and fitting > < F -To re-adjust the sender wheel

Leon Mk2

Engine speed senderG28: Removing and installing, engine code BMS
Engine speed sender -G28-: Removing and installing, engine code BMS
Removal:
–  Remove the sound insulation → Bodywork - exterior fitting work; Rep. gr.50
–  Choke the coolant hoses using the pressure clamp on the oil radiator side and release them.
–  Remove the oil filter bracket.
   
–  Remove the securing bolt -arrow- through the opening in the cylinder crankshaft sump and pull out engine speed sender -G28-.
Installing
Install in reverse order of removal. The following should be taken into account: Tightening torque of the fixing screws for the engine speed sender -G28-: 5 Nm
  N13-10048

Balance shaft and shaft bracket: removing and fitting > < F -To re-adjust the sender wheel