| Removing and installing parts of exhaust system |
Note | t
| The vibration shock absorbing element in the front exhaust pipe must not be bent more than 10° - otherwise they can be damaged. |
| t
| After completing work on the exhaust system ensure that it is tension-free and remains at a sufficient distance from the bodywork. Where necessary, loosen the double clamp and the fastening clamp and place the silencer and exhaust pipe to ensure adequate separation from the bodywork at all points and check that the suspension is subject to uniform loads. |
| t
| The exhaust manifold is removed with the turbocharger → Chapter. |
| t
| Renew seals, gaskets and self-locking nuts. |
| t
| Components of the exhaust system: Assembly overview → Chapter |
| t
| Exhaust pipe front section with particle filter: Assembly overview → Chapter |
| t
| Front exhaust section with the particle filter: Removing and installing → Chapter |
| t
| Lambda probe -G39-: removing and fitting → Chapter |
| t
| Exhaust gas temperature sender 2 -G448-: removing and fitting → Chapter |
| t
| Temperature sensor behind the particle filter -G527-: removing and fitting → Chapter |
| t
| Stress-free alignment of exhaust system → Chapter |
|
|
|
