Installing hose connections with connector couplings |
Note t
| The supercharger air system should not leak |
t
| The flexible hose sleeves and the other turbocharger air system hoses must be free from oil and grease before the assembly. |
t
| Apply a lubricant for rubbers free from silicone and oil on the leaking surface and on the joint ring. Do not use lubricant products containing silicone or oil. |
t
| Replace the joint rings where damaged. |
t
| On replacing the joint ring, place it on the turbocharger hose groove and check that the joint rings cover the entire groove perimeter to prevent damage. |
t
| To fix the turbocharger hoses to their connection sleeves safely, if already used clamps are used, their bolt threads should be sprayed with an anti-corrosion spray before the assembly. |
Caution The seal in the plug-in connector can be damaged if the securing clip is in the locked position when fitting the connector. This can cause leakage. Observe installation instructions. |
|
|
|
|