Measuring radial clearance of crankshaft |
Special tools and workshop equipment required |
»Carry out the following work sequence« |
Note t
| Mark used bearings for re-installation but not on bearing surface. |
t
| Renew bearing shells worn down to base layer. |
–
| Clean bearing cap and bearing journal. |
–
| Place Plastigage corresponding to the width of the bearing on the journal or into the bearing shells. |
l
| The Plastigage must lie in the middle of the bearing shell. |
–
| Fit bearing cap and tighten bolts to 65 Nm without turning further angle and without rotating crankshaft. |
–
| Remove bearing cap again. |
–
| Compare width of Plastigage with the measurement scale. |
|
|
|