Leon Mk2
Toothed belt drive - exploded view |
1 - | Notched belt |
q | Mark direction of rotation before removing. |
q | Check for wear |
q | Do not bend |
q | Removing, installing and tensioning → Chapter. |
2 - | 120 Nm and then turn 90° further |
q | Replace |
q | Use counterhold tool -3415 - to loosen and tighten. |
q | Do not additionally oil or grease the threads and shoulder |
3 - | Crankshaft sprocket |
4 - | 20 Nm |
5 - | Idler roller |
6 - | 20 Nm and then turn 45° further |
7 - | Tensioning roller |
q | Remove engine bracket to remove and install → Chapter. |
8 - | 25 Nm |
9 - | Camshaft wheels |
10 - | 15 Nm |
11 - | 100 Nm |
12 - | Hub |
q | Use counterhold tool -T10051- to loosen and tighten. |
q | To remove, use puller -T10052-. |
q | removing and fitting → Chapter |
13 - | Toothed belt cover (rear) |
14 - | 20 Nm |
15 - | 10 Nm |
q | Replace |
16 - | Idler roller |
17 - | 50 Nm and then turn 90° further |
18 - | Hub |
q | Use counterhold tool -T10051- to loosen and tighten. |
q | To remove, use puller -T40064-. |
q | removing and fitting → Chapter |
19 - | 95 Nm |
20 - | High-pressure pump sprocket |
21 - | 20 Nm and then turn 90° further |
22 - | Coolant pump |
q | removing and fitting → Chapter |
23 - | 15 Nm |
24 - | Upper protection element for the notched belt |
25 - | Toothed belt cover (bottom) |
26 - | 10 Nm |
q | Replace |
27 - | 10 Nm and then turn 90° further |
q | Replace |
28 - | Belt pulley and vibration damper |
q | Can only be installed in one position, holes are offset. |
29 - | 5 Nm |
30 - | Protective plate |
31 - | 40 Nm and then turn 180° further |
q | Replace |
q | Observe tightening sequence → Fig.. |
32 - | Engine support |
q | removing and fitting → Chapter |
|