seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing poly V-belt with idler roller > < Assembly overview - poly V-belt drive with tensioning element and air conditioner compressor

Leon Mk2

Removing and installing poly V-belt without air conditioner compressor
Removing and installing poly V-belt without air conditioner compressor
Special tools and workshop equipment required
t  The assembly tool -T10367- will be supplied with the spare part → ETKA (Electronic parts catalogue).
t  The installation instructions will be supplied with the spare part → ETKA (Electronic parts catalogue).
Removing and installing
–  Remove noise insulation → General body repairs, exterior; Rep. gr.50.
–  Cut through poly V-belt.
–  Proceed as described in illustrated instructions.
Installation is carried out in the reverse sequence; note the following:
After completing repair:
–  Start engine and check belt running.
–  Fasten the front wheel housing liner in the front area again.
–  Install noise insulation → General body repairs, exterior; Rep. gr.50.
   

Removing and installing poly V-belt with idler roller > < Assembly overview - poly V-belt drive with tensioning element and air conditioner compressor