seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Stress-free alignment of exhaust system > < Removing and installing catalytic converter with non-engine-mounted particulate filter (right-hand drive vehicles)|Installation

Leon Mk2

Separating exhaust system
Separating exhaust system
Special tools and workshop equipment required
   
t  Body saw e.g.-V.A.G 1523 A-
t  Or
  W00-0005
t  Chain pipe cutter -VAS 6254-
t  Protective glasses
Operation process
In order to separate exhaust pipe and silence, there is a separation point in the exhaust pipe marked with indentations.
  WARNING
Wear eye protection.
  W00-10229
–  Cut through exhaust pipe at right angles using body saw at separating point -arrow 1-.
–  Position double clamp -4- on side markings -arrow 2- and -arrow 3- when installing.
  S26-0063
–  Install double clamp so that the bolt ends do not protrude beyond bottom of clamp.
l  Bolt connection faces to right.
–  Tighten bolt connections of double clamps evenly to 23 Nm.
Before tightening, align cold exhaust system free of tension → Chapter.
  A26-0277

Stress-free alignment of exhaust system > < Removing and installing catalytic converter with non-engine-mounted particulate filter (right-hand drive vehicles)|Installation