seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removal: > < Adapting correction values for injectors

Leon Mk2

Removing and installing injectors (solenoid valve injectors)
Removing and installing injectors (solenoid valve injectors)
  Caution
When installing a new partial engine, the clamping pieces of the injector must be tightened to the specified tightening torque following installation of the high pressure lines → Chapter. The clamping pieces are supplied tightened »hand tight« so that the position of the injectors can be adjusted during the installation of the high pressure lines. If these instructions are not observed, the engine could be damaged.
   
Special tools and workshop equipment required
t  Extractor -T10055A-, see equivalent → Anchor
t  Slider -T10377-, see equivalent → Anchor
t  Socket wrench insert -T40055-, see equivalent → Anchor
t  Torque wrench -V.A.G 1331-, see equivalent → Anchor.
t  Ratchet -V.A.G 1331/1-, see equivalent → Anchor
t  Support sleeves -T10411-, see equivalent → Anchor

   
t  Injector remover -T10426-
  W00-10844

Removal: > < Adapting correction values for injectors