Leon Mk2
Assembly overview |
1 - | 150 Nm and then turn 180° further |
q | Replace |
q | Lubricate |
q | Secure pulley with retaining tool -3415- |
q | When tightening, lock the crankshaft with the crankshaft stop -T10121-. |
q | The turning further angle can be measured with a commercial protractor. |
2 - | Plate |
3 - | Pulley |
q | Do not tilt during assembly |
q | Poly-V belt: removing and installing → Chapter |
4 - | Mounting bush |
q | With O-ring |
Note
Always replace the O-ring after dismounting |
5 - | Crankshaft oil seal, pulley side |
q | replace → Chapter |
6 - | cylinder block |
q | 2-part |
q | Do not loosen the bolts |
7 - | 60 Nm and then turn 90° further |
q | Replace |
8 - | Flywheel |
9 - | Intermediate plate |
q | Must sit on dowel sleeves |
q | Do not damage or bend when assembling. |
10 - | Crankshaft oil seal, flywheel side: |
q | replace → Chapter |