Leon Mk2
| Active carbon filter system - Components overview |
| 1 - | Breather line |
| q | Towards the solenoid valve 1 for the active carbon filter (pulsed) -N80- (in engine compartment) |
| q | Check that it is seated securely |
| 2 - | Pressure retention valve with connection hose |
| q | Check for secure seating. |
| q | From gravity valve on fuel tank |
| 3 - | Breather connection |
| q | Visible from below |
| 4 - | 10 Nm |
| 5 - | Throttle valve control mechanism -J338- |
| q | removing and fitting → Chapter |
| q | Clean → Chapter. |
| q | If the throttle valve control part is replaced, the new control part must without fail be adapted to the engine control unit → Chapter. |
| q | In vehicles fitted with an automatic gearbox, it is also necessary to adapt the gearbox control unit → Chapter |
| 6 - | Solenoid valve 1 for active carbon filter (pulsed) -N80- |
| q | In engine compartment, right |
| q | Valve closed with ignition switched off. |
| q | When engine is warm, valve will be activated (pulsed) by engine control unit. |
| 7 - | Connector |
| 8 - | Active carbon filter |
| q | Installation location: in front right wheel housing |
| q | Filled by the gravity valve → Item and the vent valve → Item |
| q | To remove: |
| Remove the right back wheel. |
| Remove the plate of the front right-hand side wheel housing → Remove and fit the front wheel housing; Rep. gr.66. |
| Remove the line → Item |
| Remove bolt → Item and detach tank by bottom part |
