seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Mixture preparation system, electronic inj.,Gas > < Removing and installing radiator cowling with radiator fan

Leon Mk2

Removing and installing radiator fan
   
Removing and installing radiator fan
Special tools and workshop equipment required
t  Refractometer -T10007-
t  Drip tray for workshop hoist -VAS 6208-
t  Hose clip pliers -VAS 6340-
t  Coolant charger -VAS 6096-
t  Adapter for cooling system tester -V.A.G 1274/8-

   
t  Refractometer -T10007 A-
Carry out the following work:
Removal:
  WARNING
Steam may be released when opening the expansion tank. Wear eye protection and protective clothing to avoid eye injuries and scalding. Cover the cap with a cloth and open carefully.
–  Drain coolant → Chapter.
–  Removing and installing front bumper → General body repairs, exterior; Rep. gr.63.
–  Remove the radiator → Chapter.
–  Remove radiator cowl with radiator fan → Chapter
  W00-10827
–  Unscrew bolt -1- from radiator cowl -2-.
–  Press locking tab in -direction of arrow- to unlock wiring harness -3-.
–  Push wiring harness -3- in -direction of arrow- and remove.
  N19-10766
–  Remove bolts -arrows-.
–  Remove wiring harness -3- from wiring guides of radiator cowl -2-.
–  Remove radiator fan -2-.
Installation
Installation is in the reverse sequence of removal. Note the following:
–  Fill up with coolant → Chapter.
–  Note electrical connections and routing → Current flow diagrams, Electrical fault finding and Fitting locations.
–  Install front bumper → General body repairs, exterior; Rep. gr.63.
  N19-10760
Tightening torque:
ComponentSpecified torque .
Radiator fan on radiator cowl10 Nm
Electrical wiring harness to radiator cowl3 Nm

   

Mixture preparation system, electronic inj.,Gas > < Removing and installing radiator cowling with radiator fan