SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Oil filter, oil pressure switch >
< Removing and installing oil sump
Leon Mk2
Power unit
3 cylinder Fuel-injection engine, belt drive (4 valves)
Engine lubrication / Sump, oil pump
Oil pump: removing and installing
Oil pump: removing and installing
Oil pump: removing and installing
Removal:
–
Disconnect battery
→ Electrical system; Rep. gr.27
.
–
Remove alternator
→ Electrical system; Rep. gr.27
.
–
Remove toothed belt
→ Chapter
.
–
Remove sump
→ Chapter
.
–
Remove crankshaft oil seal on belt pulley end
→ Chapter
.
–
Unscrew securing bolts
-arrows-
and remove tensioning element.
–
Unscrew oil pump securing bolts
-1-
and
-2-
.
–
Pull oil pump off dowel pins on cylinder block in a straight line.
–
Remove gasket
-1-
from dowel pins
-arrows-
.
Installation
–
Fit new gasket
-1-
onto dowel pins
-arrows-
.
–
Rotate oil pump gear to a position where 2 opposing notches
-arrows-
are aligned vertically.
–
Fit oil pump onto dowel pins.
–
Tighten new securing bolts
-1-
to 8 Nm + turn 90° further.
–
Tighten the bolts
-2-
to 20 Nm.
–
Install new crankshaft oil seal on belt pulley end
→ Chapter
.
–
Mount tensioning element using new securing bolts
-arrows-
and tighten to 8 Nm + turn 90° further.
–
Fit the oil sump
→ Chapter
.
–
Install toothed belt
→ Chapter
.
–
Install alternator
→ Electrical system; Rep. gr.27
.
Power unit
3 cylinder Fuel-injection engine, belt drive (4 valves)
Engine lubrication / Sump, oil pump
Oil pump: removing and installing
Oil filter, oil pressure switch >
< Removing and installing oil sump