Leon Mk2
Silencer with fasteners |
1 - | Front exhaust pipe with catalyst |
2 - | Mark |
q | Three times round the perimeter |
3 - | Double clamp |
q | Check assembly position → Fig. |
4 - | Dimension -a- = approx. 5 mm |
5 - | Crushed bolt |
6 - | 40 Nm |
7 - | Presilencer1) |
8 - | Suspension element |
9 - | 25 Nm |
10 - | Suspension element |
q | Renew if worn |
11 - | Union brace |
12 - | 15 Nm |
13 - | 20 Nm + 1/4 turn (90°) |
14 - | Rear silencer1) |
15 - | Mark |
q | Three times round the perimeter |
q | For double repair clamp -16- |
16 - | Double repair clamp |
q | Must be fitted up to the marks -15- |
17 - | Cutting point |
q | In case of reparation → Note |
q | With three marks round the perimeter of the connecting pipe |
1) | On the standard version the pre-silencer and the rear silencer are made up of one single piece. For repairs the pre-silencer and the silencer are supplied separately, with a double clamp, → Item. Cut the connecting pipe perpendicularly at the cutting point -17- with the tool -U-40075- → Fig.. |
Note!
|