Leon Mk2
Removing and installing fuel tank with its attachments |
1 - | Sealing cap |
2 - | Fastening ring |
3 - | Tank cap unit |
q | Removing and installing → Bodywork assembly work; Rep. Gr.55 |
4 - | Deaeration hose |
5 - | Gravity/safety valve |
q | For removal, unlock the safety tab and expulse the filler hole valve upward |
q | Check the continuity of flow from valves |
Perpendicular valve: open |
Valve inclined 90o: closed |
6 - | Connection to earth |
7 - | 4 Nm |
8 - | Filler hole unit |
q | With non-return valve |
9 - | Dust bellows |
q | After installing filler unit, fit it above the fuel tank filler hole |
10 - | Fuel tank |
q | Removing and installing → Chapter |
q | Press the antithermal plate fastening washer firmly over the bolt located on the vehicle floor |
11 - | 25 Nm |
12 - | Ring gasket |
q | Renew in case of fault |
q | Wet with fuel before installing |
13 - | Fuel gauge transmitter |
q | Check the installation position of the fuel tank → Fig. |
14 - | Cover nut |
q | Remove and fit with -U-40055- |
15 - | Supply hoses |
q | To the fuel filter → Item |
q | Clipped to the fuel tank |
q | Check for firm fitting |
q | Black |
q | To disconnect the flange the unlocking keys on the connector element must be pressed |
16 - | Return hoses |
q | From the fuel filter → Item |
q | On the connector -R- |
q | Blue or blue mark |
q | Clipped on the fuel tank |
q | Check for firm fitting |
q | To disconnect the flange the unlocking keys on the connector element must be pressed |
17 - | Deaeration valve |
q | To remove press lightly inward on the clip -arrow- and extract the valve |
q | Check → Fig. |
18 - | O-ring |
q | Renew if worn |
19 - | Dust bellows |
q | For filler hole |
Note!
|