Leon Mk2
Part II |
1 - | 120 Nm + retighten 1/4 turn (90°) + (30°) |
q | Replace |
q | To loosen and tighten, use the counter-support -T20018A- |
q | The thread and the collar must be free from oil and grease |
q | The retightening may be carried out in various stages |
2 - | 40 Nm + retighten 1/4 turn (90°) |
q | Replace |
3 - | 15 Nm |
4 - | Lower protector of the toothed belt |
5 - | 10 Nm |
6 - | Central protector of the toothed belt |
7 - | Upper protector of the toothed belt |
8 - | Toothed belt |
q | Before removing, mark the turning direction |
q | Check for wear |
q | Do not bend |
q | Removal and refitting, tensioning → Chapter |
9 - | 25 Nm |
q | Replace |
10 - | 20 Nm |
11 - | 20 Nm |
12 - | 40 Nm |
13 - | Camshaft pinion |
q | Remove using extractor -T20119- |
14 - | Tensioner roller |
q | Check the semiautomatic tensioner roller of the toothed belt → Chapter |
15 - | Return roller |
16 - | Injection pump pinion |
q | Two pieces |
17 - | 30 Nm |
18 - | Rear protector of the toothed belt |
19 - | Coolant pump |
q | Make sure it turns gently |
q | Note the fitting position |
q | For removal, it is necessary to remove the return roller |
q | Removal and refitting → Chapter |
20 - | Return roller |
21 - | Toothed belt-crankshaft pinion |
22 - | Bushing |
23 - | Injection pump |
q | Removal and refitting → Rep. Gr.23 |
24 - | Complete support |
q | For injection pump, alternator and fin pump for power steering |
q | For vehicles without air conditioning |
q | Removing and refitting the compact support in vehicles with air conditioning: → Heating, air conditioning; Rep. Gr.87 |
25 - | 45 Nm |